Dascom 7010 Programmers Manual DMX - Manual (Page 41)

1-39
Setting paper feed speed
Code [02] Sa
Setting a Paper feed speed specifying character
A or B or 1 2.0 inches (50.8 mm)/sec
C or D or 2 2.0 inches (50.8 mm)/sec
E or F or 3 3.0 inches (76.2 mm)/sec
G or H or 4 4.0 inches (101.6 mm)/sec
I or J or 5 5.0 inches (127.0 mm)/sec
K or L or 6 6.0 inches (152.4 mm)/sec
M or N or 7 7.0 inches (177.8 mm)/sec
O or P or 8 8.0 inches (203.2 mm)/sec
Q or R or 9 9.0 inches (228.6 mm)/sec
S or T or a 10.0 inches (254.0 mm)/sec
U or V or b 11.0 inches (279.4 mm)/sec
W or c 12.0 inches (304.5 mm)/sec
Note: Initial value and maximum value vary depending on the printer
model.
Function Sets paper feed speed.
Direction of feed
Power is turned on
Feeds at speed of setting STX+Sa
(of default value)
*Feeds at speed of setting Sa (or previous
paper feed section when no Sa is set
Feeds at speed of setting Pa (or default value)
Feeds at speed of setting STX+Sa (or previous
unprintable section when no STX + Sa is set)
Feeds at speed of setting Sa (or previous paper
feed section when no Sa is set
Paper feed area
Unprintable area*
Paper feed area
Printable area
Unprintable area
Unprintable area*