Dascom 7010 Programmers Manual DMX - Manual (Page 68)

1-66
Storing label format
Code s naa.aa
n Memory module specification parameter A, B, C, D, E, F, G
Allocation of module varies with command settings.
Refer to the table below.
Command Set
Allocation of
module
DMI / DMW DM4 / DM8 DPP
on-board
SD-RAM
D A B
on-board flash
memory
G B A
PCMCIA Card
(option)
E or F E or F E or F
Current memory
module
on-board
SD-RAM
on-board
SD-RAM
on-board
SD-RAM
Setting
aa..a Maximum 8 characters of format name ending with CR
code
Function Stores label format into memory module and ends label format.
This command is used differently depending on the command
set. In other words, it is used differently depending on
whether the command is designated at the end of the label
format or designated at a given position within the label format.
When designating it at a given position within the label format,
label format ending command (“E” or “X”) is required.
Refer to the table below for details.
Command Set Designated position for storing label format
DMI / DMW
Designates at the end of label format
(It is possible to omit the end command “E ”.)
DM4 / DM8
Designates at the end of label format
(It is possible to omit the end command “E ”.)
Caution
DPP
Designates at a given position within label format
(The end command "E" or " X" is required.)
Example Input data below represents that label format data is stored in the
on-board memory by using format name "NAME."
Input data [02] n Sets units to inch
[02] L Starts label format mode
D11 Sets pixel size
190000700500050PRINTER Sets data "PRINTER" with smooth
font 24pt
sANAME Stores label format name "NAME" in
on-board RAM and ends label format
mode