Dascom 7010 Programmers Manual DMX - Manual (Page 52)

1-50
Setting label width
Code [02] [1B]w nnnn
In inch unit mode, nnnn is defined as nn.nn inch, in metric unit, nnnn
is defined as nnn.n mm
Unit 0.01 inch or 0.1 mm
Setting nnnn 4-digit data Initialization value: depending on the printer
Inch system 0000 – 9999 (0 inch - 99.99 inches)
Metric system 0000 – 9999 (0 mm - 999.9 mm)
Note: Maximum setting value will be different depending on the
the printer model .
Function Sets label width. Width of label format is specified with this command.
When receiving this command, the printer will be operated as follows.
The label width set by the operation panel will be ignored.
The print buffer will be cleared and repeat operation will be cancelled.
Maximum label length will be set automatically depending on the
selected paper width.
Example Example of input data below represents paper width of 4 inch setting.
Input data [02] n Sets units to inch system
[02] [1B]w0400 Sets paper width to 4 inches
Caution When the parameter number is out of specified range will be
ignored.