Dascom 7010 Programmers Manual DMX - Manual (Page 154)

1-152
Appendix 5 Specification list of Command set
Table below are items whose specifications will be changed using the
switching function of the emulation command sets.
Command sets
Relate
d
comm
ands
Item DMI/DMW DM4/DM8 DPP
STX O Reference values for printing
starting position
0220
(2.20inches ）
0220
(2.20inches ）
0110
(1.10inches ）
Normal
printing 000 (0.00inches) 220 (2.20inches) 110 (1.10inches)
Cutter 100 (1.00inch) 340 (3.40inches) 230 (2.30inches)
Peeling 050 (0.50inches) 270 (2.70inches) 146 (1.46inches)
STX f
STX
Kf
Reference value for
optional positions
Tear off 070 (0.70inches) 290 (2.90inches) 166 (1.66inches)
on-board
SD-RAM D A B
on-board
flash memory G B A
Specified destinations
of memory modules
PC card E or F E or F E or F
STX I
STX i
STX q
STX X
STX x
s
Allocation of default module C on-board
SD-RAM
on-board
SD-RAM
on-board
SD-RAM
s Specified locations of label format
storage commands Specify to place
at the end of the
label format.
(End
command ”E”
can be omitted.)
Specify to place
at the end of the
label format.
(End
command ”E”
can be omitted.)
Specify to place
at any given
location within
the label format.
(End
command ”E”
or ”X” is
needed.)
D Pixel size initial value 11
(Horizontal/Verti-
cal 1 dot)
22
(Horizontal/Verti-
cal 2 dots )
11
(Horizontal/Verti-
cal 1 dot)
H Setting range of printing density 0 to 30
(Initial value 10)
0 to 30
(Initial value 10)
0 to 20
(Initial value 10)