Black Box COMPACT T1 MT850A - Manual (Page 340)

5-256 Compact T1 - Release 6.1
CLI Commands
status
status (ds0)
Use the status (ds0) command to display the current status of the specified DS0.
Syntax: status {ds0-addr}
Example: status a:1:1
Displays the current status of the DS0s on port 1 on slot A
(controller card), port 1, channel 1.
> status a:1:1
DS0 Rx AB Tx AB Signal T1 TP
--- ----- ----- ------ --------- --
A:1:1 11 01 EMW Traffic N
Display Descriptions
Rx AB - AB bits received by the FXS or FXO port
Tx AB - AB bits transmitted by the FXS or FXO port
Signal - Signaling mode for which the port is configured
T1 - T1 Status
TP -
Trunk Processing
{ds0-addr}
In the form of {slot:port:channel}.
slot A for the controller card, or 1-6 for service cards.
port Port number or range.
channel Channel number or range, for T1 ports.