Black Box COMPACT T1 MT850A - Manual (Page 236)

5-152 Compact T1 - Release 6.1
CLI Commands
set
set (router) voip sdpaddress
Use the set (router) voip sdpaddress command to set the address value to be used for the
origin and connection lines in the SDP.
Syntax: set {cmg_card-addr} voip sdpaddress
{gatewayid|domain-name|ip|ip-addr}
Example: set 3 voip sdpaddress domainname
The example will configure the SDP address value to match the DNS domain
name.
{cmg_card-addr}
The slot number (1-6) that contains the CMG card.
{domainname|gatewayid|ip|ip-addr}
domainname Use the DNS domain name if DNS is enabled or DMG IP address if
DNS is disabled.
gatewayid Use the MGCP gateway ID.
ip Use the CMG IP address.
ip-addr Use this IP address, in the form xxx.xxx.xxx.xxx, where xxx is a
number from 0 - 255.