Print, Print config, Print -63 – Black Box COMPACT T1 MT850A User Manual
Page 147: Print config -63
Compact T1 - Release 6.1
5-63
CLI Commands
Use the print command to display the help information or print the configuration file.
Syntax:
print {config|help}
print config
Print the configuration file for the Compact T1. The operator may then save this to a text file,
which can be sent to another Compact T1 to automatically configure the system at the original
Compact T1.
Syntax:
print config [rtr_card-addr]
[rtr_card-addr]
The slot number (1-6) that contains the Router (IP or CMG) card.
Example:
print config 5
This example would produce a configuration file of the Router in slot 5.
Adit> print config 5
set verification off
-set 5 password view {password} is manual
-set 5 password config {password} is manual
-set 5 password admin {password} is manual
-set 5 enhanced security enable is manual
-set 5 password security {password} is manual
delete 5 remote "RemoteUnit"
set 5 stp enable
rename 5 "LocalUnit" "LocalAdit"
set 5:1 ip address 192.168.3.195 255.255.255.0
add 5:1 secondary ip address 192.168.3.194 255.255.255.0
set 5:1 up
set 5:1 collision threshold high 500
add 5 remote "RemoteAdit"
reset 5
Example:
print config
This example would produce a configuration file of the Controller.
1.
While in a Telnet session to an Compact T1 select Terminal/Start Logging.
2.
Name the file.
3.
Type the CLI command
print config.
4.
Select Terminal/Stop Logging.
See Load Controller Configuration on page 16-8 for instructions to reload configuration to