Black Box COMPACT T1 MT850A - Manual (Page 159)

Compact T1 - Release 6.1 5-75
CLI Commands
set
set (ds0)
Use the set (ds0) command to setup one or all DS0s in a DS1. The command specifies DS0 or
range of DS0s, and the setting to apply.
Syntax: set {ds0-addr} {setting}
Example: set 3:1:1-4 type voice
To set the traffic type to voice on channels 1 - 4 on port 1 of slot 3.
Example: set a:1:1-4 signal emi
To set the signal type to E&M immediate start for channels 1 - 4 on port 1 of slot
A.
{ds0-addr}
List of DS0 channels to apply setting to, in the form {slot:port:channel}.
{setting}
slot A for the controller card, or 1 - 6 for service cards.
port Port number or range.
channel Channel number or range.
signal
emdw E&M delayed wink start. Used for ANI/DNS
emi E&M immediate start with ringback (used for D3 PLAR and DPT)
emicpd E&M immediate start with calling party disconnect with ringback
emw E&M wink start
gs Ground start signaling
ls Loop start signaling
plar D4 PLAR (Private Line Automatic Ringdown) signaling.
type
data Set the DS0 up to carry data (clear channel)
voice Set the DS0 up to carry voice traffic (robbed-bit signaling)