Black Box COMPACT T1 MT850A - Manual (Page 205)

Compact T1 - Release 6.1 5-121
CLI Commands
set
set (router) mgcp protocolid
Use the set (router) mgcp protocolid command to configure a global protocol ID string
which will override the default protocol ID string used in MGCP command lines. This
command applies to the CMG Router card only.
Syntax: set {cmg_card-addr} mgcp protocolid {default|
"id-name"}
Example: set 1 mgcp protocolid "MGCP 1.0 CACS"
The example will set the protocol ID string to "MGCP 1.0 CACS".
{cmg_card-addr}
The slot number (1-6) that contains the CMG Router card.
{default|"id-name"}
If the protocol ID setting is set to "default" or the null string (""), then the following default
strings will be used depending on the configured MGCP version.
default Use the default protocol ID string
"id-name" Override the default protocol ID string with this string. Identifier of up to
20 characters, enclosed in quotes.
MGCP Version Default Protocol ID
ietf10 MGCP 1.0
ietf01 MGCP 0.1
ncs MGCP 0.1 NCS 1.0