Toshiba Tecra 8100 - Manual (Page 81)

User's Manual The Keyboard 5-5
Version
1
Last Saved on 10/12/99 02:16
Tecra 8100 User's Manual – 8100_UK.DOC – ENGLISH – Printed on 13/12/99 as IM8100UK
F4 Fn +
Alarm volume: Press Fn + F4 to adjust the alarm volume to off, low,
medium or high. The first time you press Fn + F4 the volume is set to off.
Continue holding down Fn and press F4 again to change the setting. A
beep sounds to let you know the current alarm volume. The volume at
power on depends on the latest setting. It can be changed using the
Power Management Properties utility. See Chapter 1, Introduction , or
Chapter 7, TSETUP and Passwords .
Fn
F5
+
Display selection:
Pressing Fn + F5 changes the active display device.
As indicated in the table below, the changes depend on the computer’s
display type, current setting and whether you have an external monitor
connected. It can be changed using the Hardware Setup utility. See
Chapter 1, Introduction , or Chapter 7, TSETUP and Passwords .
TV is selected only in a Windows environment. If you are operating in MS-
DOS, the TV setting is skipped.
Setting Active display Change order
Auto-Selected Internal
External
Int. Ö Sim. Ö Ext. Ö TV.
Ext. Ö TV. Ö Int. Ö Sim.
Simultaneous Simultaneous Sim. Ö Ext. Ö TV. Ö Int.
The following display mode settings do not allow simultaneous display:
Resolution Colours Scanning frequency
1280 x 1024 64 K 75 Hz
1024 x 768 16 M 75 Hz
1024 x 768 16 M 85 Hz
When you press Fn + F5 with the above display modes the display setting
changes from Int. Ö Ext. Ö TV.