beautypg.com

Mode -18 – Toshiba Tecra 8100 User Manual

Page 120

background image

7-18 TSETUP and Passwords

User's Manual

Tecra 8100 User's Manual – 8100_UK.DOC – ENGLISH – Printed on 13/12/99 as IM8100UK

Enabling Hardware Setup and TSETUP access in user

password mode

A switch on the supervisor’s password command lets you enable or

disable Hardware Setup and TSETUP access in user password mode.

1.

Type SVPW/U at the DOS prompt and press Enter. One of the

following sets of messages will be displayed:

If TSETUP access is disabled (and other restrictions in effect):

USER PASSWORD MODE = Unable to run SETUP

Do you want to change the setting ?

Select Y to enable TSETUP access (and remove other

restrictions). The following message will appear:

USER PASSWORD MODE = Able to run SETUP

If TSETUP access is enabled (and other restrictions disabled):

USER PASSWORD MODE = Able to run SETUP

Do you want to change the setting ?

Select Y to disable TSETUP (and apply other restrictions). The

following message will appear:

USER PASSWORD MODE = Unable to run SETUP

2.

If you select N for either message, you will return to the DOS prompt.

To prevent a user from using this switch to access TSETUP, the supervisor

must copy the SVPW.exe file to a diskette and delete it from the hard disk.

3.

If the supervisor password is not registered, entering SVPW /U will

display the following message:

Unable to change user password mode because

supervisor password is not registered.