Television, Television -15 – Toshiba Tecra 8100 User Manual
Page 137
User's Manual
Optional Devices 8-15
Version
1
Last Saved on 10/12/99 02:16
Tecra 8100 User's Manual – 8100_UK.DOC – ENGLISH – Printed on 13/12/99 as IM8100UK
If you have selected Simultaneous under the Display options of the
Hardware Setup or TSETUP program, both the external monitor and the
internal LCD will be active when you turn on the computer. If
Auto-Selected
is chosen, only the external monitor will be active.
To change the display settings, press Fn + F5. If you disconnect the
monitor before you turn the computer off, be sure to press Fn + F5 to
switch to the internal display. Refer to Chapter 5,
details on using hotkeys to change the display setting.
Simultaneous display will not work if the external monitor, or other
device such as a projector, supports only VGA mode (640 x 480). This is
because the computer operates in the higher resolution Super VGA (800 x
600) or XGA (1024 x 768). In this case, choose Auto-Selected in
Hardware Setup or press Fn + F5 to switch to the external display.
Television
A television can be connected to the video out port on the computer. To
connect a television, follow the steps below. Also refer to Chapter 7,
, for details on setting the type of TV signal and
selecting the television as an output device.
1.
Turn the computer off.
2.
Use a composite video cable to connect the television to the video out
port.
Connecting a television
3.
Turn the television on.
4.
Turn the computer on.