Toshiba Tecra 8100 - Manual (Page 199)

User's Manual Internal Modem Guide I-1
Version
1
Last Saved on 10/12/99 02:16
Tecra 8100 User's Manual – 8100_UK.DOC – ENGLISH – Printed on 13/12/99 as IM8100UK
Appendix I
Internal Modem Guide
This manual guides you through the installation of the internal modem for
the 8100 computer. Please read through it carefully before you begin, so
you can get an overview of the procedure. Then follow the guides step by
step as you install the internal modem.
If your internal modem was preinstalled, you should read the sections
Connection procedures and Precautions and notes. Please keep this
manual for use if you upgrade your modem at a later date.
Tools
You will need the following equipment to disassemble the computer and
install the internal modem:
„ A 2 mm Phillips screwdriver to remove and replace screws.
„ Tweezers to lift out screws that may be difficult to grasp with your fingers.
Before you begin
Look over the procedures in this document before you begin installing the
internal modem. Familiarize yourself with the steps and remember the
following points:
1. After removing parts from the computer, put them in a safe place away
from the computer so they are not damaged and do not interfere with
your work.
2. You will remove and replace screws during the installation. When you
remove screws, make sure they are put in a safe place.
When you are familiar with the procedures and information in this guide,
carefully follow the steps in the next section, Removing the internal
modem.