Toshiba Tecra 8100 - Manual (Page 69)

User's Manual Operating Basics 4-9
Version
1
Last Saved on 10/12/99 02:16
Tecra 8100 User's Manual – 8100_UK.DOC – ENGLISH – Printed on 13/12/99 as IM8100UK
Removing CDs
To remove the CD, follow the steps below and refer to the
following illustration.
Do not press the eject button while the computer is accessing the
CD-ROM drive. Wait for the eject button LED to go out before you open
the drawer. Also, if the CD is spinning when you open the drawer, wait for
it to stop before you remove it.
1. To pop the drawer partially open:
• Press the eject button when the computer’s power is on.
• Insert a slender object such as a straightened paper clip into the
eject hole when the power is off.
Gently pull the drawer out until it is fully opened.
2. There are indentations on the sides of the drawer to let you grasp the
CD. Hold it gently and lift it out.
When the drawer is fully opened, the edge of the computer will extend
slightly over the CD tray. Therefore, you will need to turn the CD at an
angle when you remove it.
Removing a CD
3. Push the centre of the drawer to close it. Press gently until it locks into
place.