Toshiba Tecra 8100 - Manual (Page 146)

9-6 Troubleshooting User's Manual
Tecra 8100 User's Manual – 8100_UK.DOC – ENGLISH – Printed on 13/12/99 as IM8100UK
Battery
If you suspect a problem with the battery, check the DC IN indicator as
well as the Battery indicator. For information on indicators and battery
operation see Chapter 6, Power and Power-Up Modes .
Problem Procedure
Battery doesn’t power
the computer
The battery may be discharged. Connect the
AC adaptor to charge the battery.
If the system fails to start up by the Alarm Power
On, the battery may be low. Connect the
AC adaptor to start up the system and charge
the battery.
Battery doesn’t charge
when the AC adaptor
is attached (Battery
indicator should glow
orange)
If the battery is completely discharged, it will not
begin charging immediately. Wait a few minutes.
If the battery still does not charge, make sure the
outlet is supplying power. Test it by plugging in
an appliance.
Check if the battery is hot or cold to the touch. If
the battery is too hot or too cold, it will not charge
properly. Let it reach room temperature.
Unplug the AC adaptor and remove the battery to
make sure the terminals are clean. If necessary
wipe them with a soft dry cloth dipped in alcohol.
Connect the AC adaptor and replace the battery.
Make sure it is securely seated.
Check the Battery indicator. If it does not glow,
let the computer charge the battery for at least
20 minutes. If the Battery indicator glows after
20 minutes, let the battery continue to charge at
least another 20 minutes before turning on the
computer.
If the indicator still does not glow, the battery may
be at the end of its operating life. Replace it.
If you do not think the battery is at the end of its
operating life, see your dealer.
Battery doesn’t power
the computer as long
as expected
If you frequently recharge a partially charged
battery, the battery might not charge to its full
potential. Fully discharge the battery, then try to
charge it again.
Check the power consumption settings in Power
Saver or TSETUP. Consider using a power
saving mode.