Pc card -13, Pc card – Toshiba Tecra 8100 User Manual
Page 153
User's Manual
Troubleshooting 9-13
Version
1
Last Saved on 10/12/99 02:16
Tecra 8100 User's Manual – 8100_UK.DOC – ENGLISH – Printed on 13/12/99 as IM8100UK
PS/2 mouse
Problem
Procedure
On-screen pointer
does not respond to
PS/2 mouse operation
Check that the PS/2 mouse cable’s 6-pin
connector is firmly connected to the
mouse/keyboard port.
You may have connected the mouse after turning
the computer on. Turn off the computer, make
sure the mouse is firmly connected and turn the
computer back on.
Is your software configured to recognise the
mouse? Check the software documentation.
If problems persist, contact your dealer.
Serial mouse
Problem
Procedure
On-screen pointer
does not respond to
serial mouse
operation
Check for a firm connection between the
computer’s serial port and the cable’s 9-pin
connector.
Did you connect the mouse before turning on the
computer?
Is the Serial port option in Hardware Setup
or TSETUP program set properly?
Is your software configured to recognise the
mouse? Check the software documentation.
If problems persist, contact your dealer.
PC card
Refer also to Chapter 8,
Problem
Procedure
PC card error occurs
Reseat the PC card to make sure it is firmly
connected.
Make sure the connection between the external
device and the card is firm.
Check the card’s documentation and the online
manual for CardWorks.
If problems persist, contact your dealer.