Toshiba Tecra 8100 - Manual (Page 155)

User's Manual Troubleshooting 9-15
Version
1
Last Saved on 10/12/99 02:16
Tecra 8100 User's Manual – 8100_UK.DOC – ENGLISH – Printed on 13/12/99 as IM8100UK
TV output signal
Problem Procedure
Display on TV is poor Make sure the TV type is correct for your area:
NTSC (US), PAL (Europe) or NTSC (Japan).
No display Try adjusting the contrast and brightness controls
on the external monitor.
Press hotkeys Fn + F5 to change the display.
Refer to Chapter 5, The Keyboard .
If problems persist, contact your dealer.
If you turn the computer off in Resume mode while the display is on TV,
the computer will select either the internal LCD or an external computer
CRT as the display device.
USB
Refer also to your USB device’s documentation.
Problem Procedure
USB device does
not work
Check for a firm cable connection between the
USB ports on the computer and the USB device.
Make sure the USB device drivers are properly
installed. Refer to your Windows 95
documentation for information on checking the
drivers.
If you are using an operating system that does
not support USB, you can still use a USB mouse
and/or USB keyboard. If these devices do not
work, make sure the USB Legacy Emulation item
in TSETUP is set to Enabled.
This feature works only for mouse and keyboard.
Also, the mouse and keyboard must be
connected, before you boot the computer.
If problems persist, contact your dealer.