Using the microphone, Connecting the modem, Using the microphone -14 connecting the modem -14 – Toshiba Tecra 8100 User Manual
Page 74: Connecting the internal modem -14, Connecting the internal modem
4-14 Operating Basics
User's Manual
Tecra 8100 User's Manual – 8100_UK.DOC – ENGLISH – Printed on 13/12/99 as IM8100UK
Using the microphone
Your computer has a built-in microphone that can be used to record
monaural sounds into your applications. It can also be used to issue voice
commands to applications that support such functions.
Since your computer has a built-in microphone and speaker, “feedback”
may be heard under certain conditions. Feedback occurs when sound
from the speaker is picked up in the microphone and amplified back to the
speaker, which amplifies it again to the microphone.
This feedback occurs repeatedly and causes a very loud, high-pitched
noise. It is a common phenomenon that occurs in any sound system when
the microphone input is output to the speaker (throughput) and the
speaker volume is too loud or too close to the microphone.
You can control throughput by adjusting the volume of your speaker or
through the Mute function.
To adjust the volume or activate Mute in Windows 95/NT, click the Start
button, point to Programs, point to Accessories, point to Multimedia
and click Volume Control.
In Windows 98, click the Start button, point to Settings, and click
Control
Panel. Next, double-click the Multimedia icon, then select the
Audio
tab and double-click the icon in the Playback group to open the
Volume Control
panel.
In the Volume Control panel, you can use the Microphone Volume slide
bars to adjust the volume level or click Mute at the bottom of the panel.
Connecting the modem
This section describes how to connect and disconnect the internal modem
to a telephone jack. The modem is not supported in some marketing
regions.
In case of a lightning storm, unplug the modem cable from the telephone
jack.
Connecting the internal modem
A standard modular cable is supplied with the internal modem. Follow the
steps below to connect the internal modem to a telephone jack.
Connect only to analog lines. Do not connect to a digital line. A digital
connection will damage the modem.
1.
Turn the connector so that the small connecting lever faces up.
2.
Squeeze the lever and plug the connector into the computer’s RJ11 jack.