Toshiba Tecra 8100 User Manual
Page 113
User's Manual
TSETUP and Passwords 7-11
Version
1
Last Saved on 10/12/99 02:16
Tecra 8100 User's Manual – 8100_UK.DOC – ENGLISH – Printed on 13/12/99 as IM8100UK
Parallel
Use the Windows 95 Device Manager to change these settings. Refer to
your Windows 95 documentation. The Parallel Port field lets you set the
I/O address for the parallel port and the Parallel Port Mode.
When the Parallel Port Mode (see settings below) is set to Standard
Bi-directional, the options are:
LPT setting
I/O address
Interrupt level
LPT 1
378H
7
LPT 2
278H
5
LPT 3
3BCH
7
Not Used
(Disables port)
Others
(Other settings made automatically by
plug-and-play operating systems)
When the Parallel Port Mode (see settings below) is set to ECP, the DMA
channel can also be set to 1, 2 or 3. The default is 3.
LPT setting
I/O address
Interrupt level
DMA Channel
LPT 1
378H
7
3
(Default)
LPT 2
278H
5
3
LPT 3
3BCH
7
3
Not Used
(Disables port)
Others
(Other settings made automatically by
plug-and-play operating systems)
OPTION
DMA = Channel 1, Channel 3 (Default)
PCI bus
This item displays the interrupt level for the CardBus in the computer. It is
for information only and cannot be changed. It appears only in TSETUP.
PCI BUS = IRQ **
(Interrupt level is displayed)
If the system cannot assign an interrupt level to the PCI bus the display
will read:
PCI BUS = IRQ Not Used
In this case, the system will sound a warning beep when you connect the
Expansion Station and turn on the computer. Also, the following on the
Expansion Station cannot be used: PCI bus slots