Xerox WorkCentre M123-M128-6336 - Manual (Page 79)

Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128/133 System Administration Guide 79
7 TCP/IP (LPD or Port9100)
This chapter explains how to set up the machine to print from a Windows computer
through LPD or Port9100. The following information is provided.
Information Checklist – page 79
TCP/IP (LPD or Port9100) Environments – page 80
TCP/IP (LPD or Port9100) Installation – page 80
Installation Procedure – page 80
Network Communication Setup – page 81
Workstation Setup – page 82
Test Print – page 83
Information Checklist
Before starting these procedures, make sure that the following items are available or
have been performed.
If problems are encountered during machine setup, refer to the Problem Solving
chapter for assistance.
CAUTION: Do not connect the network cable to the machine until instructed to
do so.
Item By
An existing operational network utilizing TCP/IP is required. These
procedures are not designed to install a network. Customer
Obtain and record the following information:
• IP address
• Gateway address
• Subnet mask
• Host name
Refer to the glossary for additional information about the Gateway
Address and Subnet mask, if needed. Customer
Test the machine to make sure that it is installed fully and functioning
correctly. Customer
Install the print driver. Customer