Xerox WorkCentre M123-M128-6336 User Manual
Page 108
11 CentreWare Internet Services
108
Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128/133 System Administration Guide
1.
At the CentreWare Internet Services home page for the machine, select the
[Properties] tab.
2.
In the [Properties] frame, select the plus symbol [+] to the left of the [Protocol
Settings] folder.
3.
Select [SNMP].
4.
Set up the following options to be displayed in the frame.
• Community Name (Read Only)
• Community Name (Read/Write)
• Community Name (Trap Notification)
• System Administrator
5.
Select [Apply New Settings] to reflect the new setting.
6.
Enter the user ID and password then select [OK].
NOTE: The default user ID is "11111" and the default password is "x-admin".
7.
When the reboot message appears, select [Reboot].
NOTE: For more information about the contents of items, refer to the CentreWare
Internet Services chapter of the User Guide.
IPP
This page allows you to configure the IPP settings for the following options.
NOTE: Some settings on this page will only be available after you restart CentreWare
Internet Services, or after the machine is switched off and on.
1.
At the CentreWare Internet Services home page for the machine, select the
[Properties] tab.
2.
In the [Properties] frame, select the plus symbol [+] to the left of the [Protocol
Settings] folder.
3.
Select [IPP].
4.
Set up the following options to be displayed in the frame.
• Port Number
• Add Port No.
• TBCP Filter (Only available when the optional PostScript Kit is installed.)
• Administrator Mode
• DNS
• Connection Time-Out
5.
Select [Apply New Settings] to reflect the new setting.
6.
Enter the user ID and password then select [OK].
NOTE: The default user ID is "11111" and the default password is "x-admin".