Xerox WorkCentre M123-M128-6336 - Manual (Page 17)

Cabling
Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128/133 System Administration Guide 17
1. Press the power switch to the
position.
NOTE: If the machine does not start
up, check that the RESET button on
the back of the machine is in the
reset position (depressed).
Powering Off
When you switch off the machine, if it is equipped with the optional hard disk, it remains
on for approximately 10 seconds while it stores files and prepares for shutdown. The
machine then shuts down completely.
CAUTION: Wait at least 20 seconds between powering the system on and off.
Failure to do this could cause damage to the hard disk.
Cabling
Interface Ports
The machine has multiple interface ports as shown in the following diagram.
Parallel Port
Ethernet Port
USB Port