Xerox WorkCentre M123-M128-6336 - Manual (Page 50)

4 UNIX TCP/IP
50 Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128/133 System Administration Guide
15. When you have finished establishing TCP/IP, select [Close] from the [Protocol
Settings] screen.
Workstation Setup
This section explains how to change the workstation OS for Solaris, SunOS, and HP-
UX workstations. Refer to the relevant instructions below.
Solaris – page 51
SunOS – page 52
HP-UX – page 53
Print language/mode/logical printer
A printer name for the logical printer should correspond to the print language/mode to
be used for printing, or to the Logical Printer Number which was registered through
CentreWare Internet Services.
*: Requires PostScript Option Kit
You can also add output parameters to the above printer name. The parameters are
the same as those for -C option. Insert “_” between the printer name and output
parameter, for example “PS_A4”.
NOTE: If specifying a different printer name, the print language or mode specified on
the touch screen of the machine is used.
NOTE: When setting print languages/modes from the same workstation to a single
printer, it is recommended to set one kind of each. If two or more kinds of languages/
modes are set, the workstation may display the same job number for some queies
(lpq).
Printer Name Print Language/Mode/Logical Printer
PS* PostScript
PSASC/PSA* PostScript
PSBIN/PSB* PostScript
PCL PCL
LP Print language specified on the touch screen of the machine.
DUMP/DMP Dump mode
AUTO/ATO Auto detection mode
TIFF/TIF TIFF direct print
TIFF%n TIFF (%n: Logical Printer Number 1 to 10 which were
registered through CentreWare Internet Services.)
PS%n* PostScript (%n: Logical Printer Number 1 to 10 which were
registered through CentreWare Internet Services.)