Xerox WorkCentre M123-M128-6336 - Manual (Page 57)

Printing
Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128/133 System Administration Guide 57
NOTE: Print data which consists of multiple files sent in one print instruction cannot be
deleted file by file. All the files will be deleted together.
NOTE: This command is invalid if no options are specified, or if there is no print data
which matches the option.
NOTE: You can only delete print data from the same workstation used to send the
print data. You cannot delete print data sent by other workstations.
NOTE: When a command to delete print data is received, the file will be deleted even
if it is in the process of being printed. Any unprinted data will be cancelled after the file
has been deleted.
Example
To delete the print data from printer fxPS for job number 27, enter the following
command.
%cancel fxPS-27
To delete all the print data from printer fxPS, enter the following command.
%cancel fxPS -e
SunOS
This section describes printing from a workstation running SunOS. See the manuals
supplied with the workstation for full details.
Print (lpr)
The lpr command is used to print.
Command format
/usr/ucb/lpr [-P printer name] [-# number of copies]
[-C parameter] File name
Command options
The following command options are available.
• -P printer name
This option specifies the printer name registered at /etc/printcap. If this option is
omitted, print data will be output to the default printer lp.
• -# number of copies
This option specifies the number of copies. If one lpr command is issued to print
multiple files, the number of copies specified by this option will apply to all the files.
This option is only valid in the spool mode.
• -C parameter
To print from the machine using the PostScript language, use the -C option to specify
the form of output.