Xerox WorkCentre M123-M128-6336 - Manual (Page 102)

11 CentreWare Internet Services
102 Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128/133 System Administration Guide
Using CentreWare Internet Services to Configure Settings on
the Machine
This section provides the full listing of the items that can be set for each port through
CentreWare Internet Services.
For a description about each item, refer to the CentreWare Internet Services chapter of
the User Guide. Refer to [Properties] > [Protocol Settings] or [Port Settings] for links to
each page.
NOTE: The following items display only if the port is activated. To activate a port
through CentreWare Internet Services, select [Port Status], and then the required port.
Ethernet – page 102
Parallel – page 103
USB – page 103
EtherTalk – page 104
SMB (Microsoft Networking) – page 104
NetWare – page 105
TCP/IP – page 106
LPD and Port9100 – page 107
SNMP – page 107
IPP – page 108
E-mail – page 109
HTTP – page 110
UPnP – page 110
SSDP – page 111
LDAP – page 111
Ethernet
This page allows you to configure the Ethernet settings for the following options.
NOTE: Some settings on this page will only be available after you restart CentreWare
Internet Services, or after the machine is switched off and on.
1. At the CentreWare Internet Services home page for the machine, select the
[Properties] tab.
2. In the [Properties] frame, select the plus symbol [+] to the left of the [Port Settings]
folder.
3. Select [Ethernet].
4. Set up the following option to be displayed in the frame.
• Ethernet Settings
5. Select [Apply New Settings] to reflect the new setting.
6. Enter the user ID and password then select [OK].