Konica Minolta bizhub 282 - Manual (Page 275)

8 Troubleshooting
8-12 362/350/282/250/222/200
Tro
uble
s
hoo
tin
g
Chapter 8
IP relay operations and others
The wrong paper size
is used for printing. The setting in the “Paper Se-
lect Method” box was not
specified correctly. Check the setting specified in the “Pa-
per Select Method” box.
The settings in the “Paper
Settings” group box were not
specified correctly. Check the settings specified in the
“Paper Settings” group box.
The wrong paper size is used
for scanning. Specify a setting beside “Scan Area”,
and then try automatically printing
again.
The setting for automatically
rotating the image is not spec-
ified. Select the “Automatically Rotates Im-
age when Image Orientation is different
from Paper Orientation.” check box in
the Print Property dialog box.
There is loss on the
edges of the print re-
sult. The setting that considers the
printer’s printable area is not
selected. If there is a slight loss on the edges, se-
lect the “Minimal” check box in the
Print Property dialog box.
“Top Left” is selected beside
“Position”. If there is a slight loss at the top and the
left edges, select “Center” beside “Po-
sition” in the Print Property dialog box.
The print result does
not fit within the pa-
per. The setting to reduce the im-
age to fit within the paper is
not selected. Select the “Adjust Image to Fit to Paper
Size” check box in the Print Property
dialog box.
The print result is not
the same size as the
original image. Different paper is selected. Select “Print on Paper Same as Image
Size” beside “Paper Select Method” in
the Print Property dialog box.
The “Minimal” check box is
selected. Clear the “Minimal” check box in the
Print Property dialog box.
“Center” is selected beside
“Position”. Select “Top Left” beside “Position” in
the Print Property dialog box.
There is a pattern
(moiré patterns) in
the print result. A pattern may appear with
some printers. Change the resolution, and then try au-
tomatically printing again.
The automatic print-
ing operation is slow. The image data is large. Reduce the resolution, and then try au-
tomatically printing again.
Problem Cause Remedy
A fax cannot be sent
from this machine. The communication mode for
gateway transmissions is in-
correctly specified. Check the settings for gateway trans-
missions.
[Network Settings]
does not appear in
the Administrator
Management screen. The device is not operating
correctly. Contact your service representative.
Problem Cause Remedy