Konica Minolta bizhub 282 - Manual (Page 257)

7 Specifying management settings
7-26 362/350/282/250/222/200
Sp
ecif
yin
g
man
age
men
t
set
ti
ngs
Chapter 7
*If the specified timeout time is short, for example, 5 or 10 minutes, the status
of a document queued to be sent from a relay machine or the G3 transmis-
sion time for the relay machine and recipient may cause a timeout (failed
transmission).
Specifying settings to limit the use of communication modes–1 (mode
475)
Specify whether to permit or prohibit the use of individual communication
modes. Prohibited communication modes do not appear in their selection
screens.
2
Note
Programmed one-touch dial buttons can be used for transmission even
if a prohibited communication mode has been specified.
If all communication modes are prohibited (modes 475 to 477), some
screens, such as those for specifying transmission settings, may not nor-
mally be displayed.
Settings at time of purchase
Specifying the setting
During the production of this unit, the settings in the shaded cells were se-
lected. The numbers on the right side indicate the page numbers with de-
scriptions for the corresponding function.
Bit 7 6 5 4 3 2 1 0
Setting 0 0 0 0 0 0 0 0 (HEX: 00)
Bit Description Setting Description Page Refer-
ence
7 Specifies whether or
not the use of TCP/
IP is prohibited. 0 Permitted ----------
1 Prohibited
6 Specifies whether or
not the use of LPD is
prohibited. 0 Permitted ----------
1 Prohibited
5 Specifies whether or
not the use of a
RAW port is prohib-
ited. 0 Permitted ----------
1 Prohibited
4 Specifies whether or
not the use of SLP is
prohibited. 0 Permitted ----------
1 Prohibited