Balboa Water Group Titan Bath Control - Manual (Page 51)

4 Button Bath Control User Guide -
therapy option
Increase speed reduce speed
Please see reverse side for more information.
Power up
• Upon power up, the LEDs flash as
the bath control goes through a self
diagnostic check. Once the LEDs
stop flashing, your Therapy Session
is ready to begin.
session timer
• Turning on a device starts a Session
Timer that lasts for 20 minutes.
optional heated Quiet-flo Blower
• Any time the blower turns on, the
heater turns on with it.
Therapy, Option, Speed Buttons
Therapy
single speed
• Press the button to turn Therapy On or Off.
variable speed
• Press the button once to turn Therapy On or Off.
• holding the button ramps the speed to high speed, then ramps down to
lowest speed. The action then repeats. Release on the desired speed.
• Pressing twice at startup puts Therapy in Wave mode.
Light (Option 1 only)
• The light can be controlled independently of all other features.
• Aux (if used) may be used for Pillow, Waterfall, or Backjet.
Blower (Optional)
speed
• If the Blower is off, press the Blower button once to turn it on.
• If you press and hold the Blower button, it ramps to and from the highest
to lowest speed. If you press and hold the Blower button again, it
continues to ramp repeatedly. The action then repeats. Release on the
desired speed.
• If the Blower is on, press the Blower button once to turn the Blower Off.
modes (turn on, beginning with blower off)
• Press the Blower button twice to put the Blower in Pulse mode, or
• Press the Blower button three times to put the Blower in Wave mode.
40934 A July 29, 2013