Led messages led definition, Purge cycle – Balboa Water Group Titan Bath Control User Manual
Page 50
LED Messages
LED Definition
session timer on
Tells you a device button has been pressed and a Session
Timer is running.
Water level detected
Tells you adequate water level has been reached to run the
system. (Sensor required.)
favorite setting on
Tells you that your favorite setting is running.
error
Tells you that your system needs servicing.
(See Error Codes for Bath Button Displays.)
no therapy Water detection (sensor required)
• If no water is detected:
a) The water devices all shut down,
b) The Water Level Detected LED flashes for several seconds before it turns off.
system error detection
• If an error occurs in the bath system, the red ERROR LED will flash.
• In addition, the three remaining LEDs stay lit in a specific on/off pattern that
reveals a diagnostic code of the error. If this should occur, take note which of
the three lights are on or off. This information will help technical support in
diagnosing the error.
system reset
• Press and hold the two top buttons for 5 seconds.
• Continue to hold the two top buttons 5 seconds longer to restart the system.
Purge Cycle
• A Purge Cycle removes standing water from the plumbing and dries the air
delivery system. This helps maintain a sanitary plumbing system.
• Once the bath control thinks you’re finished using the bath, it schedules a
Purge Cycle. The Session Timer LED flashes periodically to indicate that a
Purge Cycle will soon begin.
• Certain actions may cancel the planned Purge Cycle. This is normal.
Otherwise, after a number of minutes, the 1-minute Purge Cycle will begin. At
that point, the Session Timer LED will light continuously.
• When the Purge Cycle ends, all equipment turns off and the Session Timer LED
turns off.
© 2013 Balboa Water Group
40933 A July 29, 2013