Balboa Water Group Stand Alone Quiet-Flo Blower - 4 Buttons - Manual

4 Button Bath Control
Blower Light
Increase Speed Reduce Speed
Stand-alone Blower, Light, Speed Buttons
Please see reverse side for more information.
Blower
Speed
If the Blower is off, press the Blower button once to turn the Blower On at UÊ
its highest speed, or
Press and hold the Blower button. If off, the Blower starts up at low speed,
UÊ
ramps up to highest speed, then ramps down to lowest speed. The action
then repeats. Release on the desired speed. If you press and hold the
Blower button again, it continues to ramp repeatedly.
If the Blower is on, press the Blower button once to turn the Blower Off.
UÊ
Modes
Press the Blower button twice to put the Blower in Pulse mode, or UÊ
Press the Blower button three times to put the Blower in Wave mode. UÊ
Light
If you have a light installed, the light can be controlled independently of all UÊ
other features.
Some lighting options have unique operation for color changes.
UÊ
See the manual for any special light system that may be installed. UÊ
Increase/Reduce Speed
Press and hold the + or - button to increase or decrease the speed smoothly. UÊ
Power Up
Upon power up, the LEDs flash as UÊ
the bath control goes through a self
diagnostic check. Once the LEDs stop
flashing, you may use the control.
Session Timer
Turning on a device starts a Session UÊ
Timer that lasts for 30 minutes.
When all devices are turned off,
UÊ
either manually or when Session
Timer expires, the previous state can
be restored by pressing the Blower
button within 5 seconds.
Optional Heated Quite-Flo Blower
Any time the blower turns on, the UÊ
heater turns on with it.
Control Panel
(90013)
7 LED Bulb Cluster
(59007-V)
Light Adapter Cable
4 Pin Din to 2 pin Amp plug
(25750)
Cable Bath 8 Pin
Mini Din 6ft
(25569)
2” Bath Light
(59200, Front Access)
8' Water
Detect Cable
(99742)
(Optional)
Blower 600w Htr 115v 3spd
(8141-6320 )
Bulb Holder with
2 pin Amp plug
(59102)