Balboa Water Group Titan Bath Control - Manual (Page 46)

LED Messages
LED Definition
Purge Cycle
• A Purge Cycle removes standing water from the plumbing and dries the air
delivery system. This helps maintain a sanitary plumbing system.
• Once the bath control thinks you’re finished using the bath, it schedules a
Purge Cycle. The Session Timer LED flashes periodically to indicate that a
Purge Cycle will soon begin.
• Certain actions may cancel the planned Purge Cycle. This is normal.
Otherwise, after a number of minutes, the 1-minute Purge Cycle will begin. At
that point, the Session Timer LED will light continuously.
• When the Purge Cycle ends, all equipment turns off and the Session Timer LED
turns off.
system error detection
• If an error occurs in the bath system, the red ERROR LED will flash.
• In addition, the three remaining LEDs stay lit in a specific on/off pattern that
reveals a diagnostic code of the error. If this should occur, take note which
of the three lights are on or off. This information will help technical support
in diagnosing the error.
system reset
• Press and hold the two top buttons for 5 seconds to turn all equipment
off. Continue to hold the two top buttons 5 seconds longer to restart the
system.
session timer on
Tells you a device button has been pressed and a
Session Timer is running.
Water level detected
Tells you there is still water in the tub. (Sensor
required.)
error
Tells you that your system needs servicing.
(See Error Codes for Bath Button Displays.)
© 2013 Balboa Water Group 40936 A July 29, 2013