Balboa Water Group Freedom Series Conversion Kit - Manual

STEP 1: Make sure spa pump is not running.
STEP 2: Remove existing components by pressing palm against front of jet and rotating 1/8 turn counter clockwise.
This will remove escutcheon (#5) or grill (#6) from wall fitting. To remove retaining ring (#4) or bearing/nozzle
adapter (#7), place ends of needle nose pliers into notches and unthread, turning part counter clockwise.
NOTE: Hydro Air part number 10-5875 AF Mark II wrench can be used.
STEP 3: Making sure seat ring (#2) is still in place inside jet, insert eyeball (#3) into jet and thread in retaining ring (#4)
turning clockwise until snug against eyeball.
STEP 4: Place escutcheon (#5) on wall fitting (#1) by lining up tabs on wall fitting with slots on escutcheon. Press
escutcheon in towards spa and twist 1/8 turn clockwise until escutcheon locks into place.
NOTE: If using metal escutcheon (#8), leave off plastic twist lock escutcheon (#5) and press metal escutcheon into
wall fitting (#1) until flange touches wall fitting.
88-FS00 Rev A June 24, 2009
PART NUMBER DESCRIPTION
For: 10-FS00TW Whirlpool Trim Kit
10-FS00TD Directional Trim Kit
10-FS00TA Adjustable Trim Kit
16-FS00TM Microssage Trim Kit
FREEDOM SERIES CONVERSION KIT INSTALLATION INSTRUCTIONS