Balboa Water Group Titan Bath Control - Manual (Page 21)

Manufactured under one or more of these patents. U.S. Patents: 5332944, 5361215, 5550753, 5559720, 5,883,459, 6253227, 6282370, 6590188, 6976052, 6965815, 7030343, 7,417,
834 b2, Canadian Patent: 2342614, Australian patent: 2373248 other patents both foreign and domestic applied for and pending. All material copyright of Balboa Water Group.
21
42135F
5. Drill four 3/8” holes in each corner, as shown.
6. Cut out the remaining material. Deburr the
cut area if necessary. Without removing the
adhesive from the trim ring, set the trim ring
into the hole to check for fit.
trim ring with adhesive
drill a 3/8” hole in each corner
Installing the trim ring & Panel
7. Important: Before installing the assembly, be aware that
depending on the trim ring assembly version, the panel may
go into the trim ring one way only. Check for this before
installing the trim ring and panel. The trim ring cut-out is
opposite the display. See below.
8. If the trim ring fits properly into the hole, is aligned, and
the orientation of the panel is correct, install the trim ring
and panel. Remove the masking tape, make sure the bath
surface is clean for good adhesion, remove the adhesive
backing from the back of the panel trim ring (the adhesive
should be fully exposed), then place the trim ring into the
hole and press down firmly.
9. Plug the 8-pin panel cable into the panel system board, and
clip on the cable retainer. Place the 8-pin cable through the
bath cut-out opening, then place the topside panel into the
cut-out. Press down firmly along the trim ring. It will snap
into place.
10. Route the 8-pin cable to the control box.
Titan 6 Button Bath Panel Cut Out Pattern _062512
6.375”
2.375” 1 - 3/8”
4 - 1/4”
Drill a 3/8” hole in each corner
the trim ring cut-out is opposite the display
step no 9
clip on the cable retainer