beautypg.com

Creating a configuration 40 bath system – Balboa Water Group Titan Bath Control User Manual

Page 28

background image

Manufactured under one or more of these patents. U.S. Patents: 5332944, 5361215, 5550753, 5559720, 5,883,459, 6253227, 6282370, 6590188, 6976052, 6965815, 7030343, 7,417,

834 b2, Canadian Patent: 2342614, Australian patent: 2373248 other patents both foreign and domestic applied for and pending. All material copyright of Balboa Water Group.

28

7/14/14

A bath "system" is actually a specific bath configuration of the
equipment installed. What type of equipment is installed and
how they're a arranged determines the configuration setup
as seen in the Bath Control Configuration Tables. That specific
configuration number is then assigned through the panel,
which must be inputted in order to have the equipment operate
properly.

Bath setuP

The following pages demonstrate installation of equipment
using Configuration Number 40 (or, C40 in the table). This
configuration was chosen for demonstration purposes; yet,
any configuration could have been used. C40 provides an
opportunity to show how multiple solenoid valves are installed.

InstallInG multIPle solenoId valves

Further examples of solenoid valve use are as follows: one
solenoid valve is used for a waterfall or cleaner, two valves are
used to operate either a foot jet, neck jet, or pillow, and three
valves are used for a backjet. According to the Bath Control
Configuration Table indicates that C40 operates a backjet
(button 5) and a pillow (button 6). As noted previously, keep the
following in mind:
• The controller box can accommodate five discrete pairs of a

twin pluggable blocks. 10 solenoid valves can be controlled
from one PVC box. If more solenoid valves are installed,
two valve control boxes (90018) are needed.

desired features

equipment needed

Oval bathtub

Tub

6 button bath panel

6 button bath panel w/trim

Pulsating pillow and back jet

PVC (Primary Valve Control is needed to control solenoids)
Pump
Pillow (2 jets)
Backjet (6 jets)
(2) One inlet, three outlet solenoids
(1) One inlet, two outlet solenoid

Blower with heater

Quiet-Flo Blower (8141-6320)

Accessories:
Safety features
Temperature read out

Chromatherapy light (7 LED Bulb Cluster)
Water level detection cable
Water temperature sensor

BasIc lIst for a Bath setuP:

When creating a bath system, one place to begin is to consider
the following:
1. Determine what features you’d like
2. Determine the equipment needed
3. Install the equipment to create the system
4. Configure the bath button per the configuration table

Creating a Configuration 40 Bath System

• If two or more control boxes are connected, whether they

are PVC or VSC, they must be positioned and configured
properly so that they can communicate via the wireless
IR link.

• Although the paired valve connectors on the control boxes

are non-polarized (AC), the solenoids should be wired to the
valves in a consistent pattern.

c40 overvIeW