Balboa Water Group Hand Held Jet For Magna Series User Manual
Hand held jet for magna series instructions
88-4046, Rev B June 17, 2009
HAND HELD JET FOR MAGNA SERIES INSTRUCTIONS
1. Turn off circulation pump.
2. Remove eyeball (#7) or flowpath (#8 or #9) from the jet by pulling on snout of eyeball or flowpath
spout.
**It may be easier to remove therapy option with pump running and jet open. Block outlet
with index finger and pull on snout of eyeball (#7) or flowpath (#8 or #9).
3. Insert the adapter (#1) firmly into the jet. Rotate the adapter (#1) counterclockwise approximately
90
o
until it clicks.
TO REMOVE THE ADAPTER (#1), turn it counterclockwise approximately 1/8 of a
turn or 45
o
and pull straight out.
4. The hole on the float (#3) must be above the water level to draw air.
5. Start the circulation pump.
6. Squeeze the trigger (#2) to start the hand held jet (#4) and release the trigger (#2) to stop it. If you
do not get water flow through the hand held jet, rotate the jet handle (#10) 90° to be sure jet is open.
TO CHANGE THERAPY OPTION IN HAND HELD JET:
Insert cage and eyeball (#5) (or flowpath #6) into hand held jet (#4) by pressing firmly to snap into place.
1. ADAPTER
2. TRIGGER
3. FLOAT
4.
HAND HELD JET
5.
CAGE & EYEBALL ASSEMBLY
6.
DUAL PORT FLOWPATH
7. EYEBALL
ASSEMBLY
8.
DUAL PORT FLOWPATH ASSEMBLY
9.
SINGLE PORT FLOWPATH ASSEMBLY
10.
MAGNA SERIES JET HANDLE