Balboa Water Group Titan Bath Control - Manual (Page 43)

2 Button Bath Control User Guide - Therapy, Light/Aux
session timer
• Turning on a device starts a
Session Timer that lasts for 20
minutes. The Timer can be changed
using User Preferences (see back).
• If a temperature sensor is available,
the temperature will display for 20
minutes once Session has started
and then during the purge cycle.
therapy light/aux
Power up
• Upon power up, the Bath Control
goes through a self diagnostic
check that lasts for about 15
seconds. The LED Display will
then show the water temperature
or a blank display, depending on
whether a water temperature
sensor is installed or not.
Therapy
single speed
• Press the button to turn Therapy On or Off.
variable speed
• Press the button once to turn Therapy On or Off.
• holding the button ramps the speed to high speed, then ramps down to
lowest speed. The action then repeats. Release on the desired speed.
• Pressing twice at startup puts Therapy in Wave mode.
Light/Aux Button
• The light can be controlled independently of all other features.
• Aux (if used) may be used for Pillow, Waterfall, or Backjet.
Blower (if installed as Aux)
speed
• If the Blower is off, press the Blower button once to turn it on.
• If you press and hold the Blower button, it ramps to and from the highest
to lowest speed. If you press and hold the Blower button again, it
continues to ramp repeatedly. The action then repeats. Release on the
desired speed.
• If the Blower is on, press the Blower button once to turn the Blower Off.
modes (turn on, beginning with blower off)
• Press the Blower button twice to put the Blower in Pulse mode, or
• Press the Blower button three times to put the Blower in Wave mode.
40939 A July 29, 2013
Please see reverse
side for more information.