Balboa Water Group Aqua-Fan - Manual

Aqua-Fan
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
SAVE THESE INSTRUCTIONS
Introduction: As a result of years of research and fine engineering, BWG introduces the Aqua-Fan Jet, an exciting new
sensation, into the hydro massage market. The patented jet derives its unique hydrotherapeutic massaging
action through the use of an oscillating wedge which converts the incoming stream of air/water mixture
into soothing, wave-like, pressure pulsations.
Plumbing: Water Line: 1.0” Pipe Glueable PVC
Air Line: 1.0” Pipe Glueable PVC
The Aqua-Fan Jet is to be located horizontally or vertically 4-18 inches below the water level on a flat wall
10” x 3”. In relation to other standard jets, the Aqua-Fan Jet shall be installed in a dead head plumbing
system with optional grouped or separate air/water combination.
Pump Selection
and Sizing:
For optimum jet performance, the system pump shall be selected as shown on Table 1.
98704500 Rev. D October 15, 2009
How To Read Table:
Select pump to be used. 1.
Select number of Aqua-Fan Jets to be installed. 2.
Find number of standard jets to be installed at the intersection between the pump line (vertical) and the number of 3.
Aqua-Fan Jets line (horizontal).
Notes:
Operating data for optimum results are: 9.0 PSI at 22 GPM. 1.
The above combination is based upon BWG’s laboratory test results and computerized spa systems simulation. 2.
Number of Standard BWG Jets
Maxim Pumps Ultra-Flow Pumps
No. of Aqua-Fans 3/4 HP 1.0 HP 1 1/2 HP 3/4 HP 1.0 HP 1 1/2 HP 2.0 HP 3.0 HP
One Aqua-Fan 2 3 5 4 6 7 8 9
Two Aqua-Fans 0 0 2 1 2 4 4 5
Three Aqua-Fans N/A N/A N/A N/A N/A 1 1 2
Table 1
Number of Standard Jets vs. Number of Aqua-Fan Jets