Balboa Water Group 4 Button C5 System Panel Instructions - Manual

Control Features:
Pump ON/OFF with water sensor control •
Pillow control ON/OFF •
Pillow control speed buttons (3 speeds) •
Automatic 30-minute run-timer for pump •
Single Speed Pump Motor Operation:
Once the system run-timer has been programmed, the pump is available for activation. Press button 1 to turn the
pump ON and press button 1 again to turn the pump OFF.
Pillow Operation Using the Speed Up/Down Keys:
The pump must first be active in order to have control of the pillow operations. A press and release of the pillow
button turns the pillows full ON and full OFF. Once the pillows are operating a press and hold of the pillow button
for 2-seconds will illuminate the speed Up/Down button LEDS. Once the LEDS are illuminated, the speed buttons
can be pressed to select from the 3 pillow speeds. The button LEDS will remain on for ten seconds of absent
button pressing.
The Automatic 30-Minute Run-Timer:
Once the system motor has been activated, an automatic timer is set to 30-minutes. The system will stay in
operation until the run-timer expires, at which time all functions will shut down. The light device timer runs
independent of the main system run-timer.
The 4-Button C5 System
Pump Pillow
Speed Up Speed Down
May 26, 2010