Panasonic VideoCam Suite 1.0 - Manual (Page 93)

Settings/Convenient information
Troubleshooting
93
An error message is displayed when
a recording drive is selected.
z Close any other software using the drive.
z An error message may be displayed when a disc is replaced. Reselect the drive.
z Other recording software may be interfering with operation. In this case, uninstall
the other recording software.
A disc error message is displayed. z When the type or the format of DVD disc does not support DVD-VR recording,
recording is impossible. (Supported discs: l11 )
Cannot record even though there is
free space in the disc. z Recording is not possible if a disc is protected. Clear the protection settings using
the device that was used to write-protect the disc.
z You cannot record a video with no sound or less than 3 seconds long in DVD-VR
format.
Error occurs while data are being
recorded to a disc. z The data may not be recorded properly due to a conflict between the DVD drive
and the DVD disc. Use discs that are recommended for the drive.
Playback may not be possible even if the recording is completed properly,
depending on the disc. Confirm playback after recording.
z Operation may not execute normally due to the condition of the drive in which the
OS is installed or that of the drive which is designated as the work area. Execute
defragmentation if necessary.
z Do not operate other recording software. Doing so may result in unsuccessful
recording or damage to the disc. Do not operate any other application, especially
those that use the DVD drive or those with a high CPU demand and high memory
consumption (recording or encoding software).
The image is distributed during
recording and is not recorded
properly.
z Close this software and restart the PC.
If the following problem occurs Check the following
MC20_eng.book 93 ページ ２００７年１０月２４日 水曜日 午後２時１分