Allied Telesis AT-PBC18 - Manual (Page 75)

PowerBlade PBC18 Installation Guide
75
13. Power ON the end-nodes.
Note
End-nodes connected to the media converter must operate with
the same duplex mode (either both full-duplex or both half-duplex
mode.)
14. Check that the LK LEDs on both ports are green. If the LEDs are OFF,
refer to Troubleshooting on page 99.
15. If the link test is successful, set the ML/LT button to the MissingLink
(ML) position. The ML LED should be green.
Caution
AT-PB1000 Series Media Converters will not pass network traffic
when a link test is being performed, thus possibly disrupting
network operation. Only when the LT/ML button or switch is in the
ML position will the media converter pass network traffic.
The PowerBlade module is now ready for use. Repeat this procedure to
install additional PowerBlade Media Converters.