Allied Telesis AT-PBC18 - Manual (Page 106)

Translated Safety Information
106
Standards: This product meets the following standards.
! 1 RFI Emission EN55022 Class A, EN61000-3-2, EN61000-3-3
! 2 Warning: In a domestic environment this product may cause radio interference in which case the user
may be required to take adequate measures.
! 3 Immunity EN55024
! 4 Electrical Safety EN60950, UL1950, CSA 950
! 5 Laser EN60825
Safety
! 6 Warning: Class 1 Laser product.
! 7 Warning: Do not stare into the laser beam.
! 8 Electrical Notices
Warning: Electric Shock Hazard
To prevent electric shock, do not remove the cover. No user-serviceable parts inside. This unit contains
hazardous voltages and should only be opened by a trained and qualified technician. To avoid the
possibility of electric shock, disconnect electric power to the product before connecting or disconnecting
the LAN cables.
! 9 Lightning Danger
Danger: Do not work on equipment or cables during periods of lightning activity.
! 10 Caution: Power cord is used as a disconnection device. To de-energize equipment, disconnect the power
cord.
! 11 Electrical - Type Class 1 Equipment
This equipment must be earthed. Power plug must be connected to a properly wired earth ground socket
outlet. An improperly wired socket outlet could place hazardous voltages on accessible metal parts.
! 12 Pluggable Equipment, the socket outlet shall be installed near the equipment and shall be easily
accessible.
! 13 Caution: Air vents must not be blocked and must have free access to the room ambient air for cooling.
U.S. Federal Communications Commission
Radiated Energy
Note: This equipment has been tested and found to comply with the limits for a Class A digital device pursuant to
Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with this instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at his own expense.
Note: Modifications or changes not expressly approved of by the manufacturer or the FCC, can void your right to
operate this equipment.
Industry Canada
This Class A digital apparatus meets all requirements of the Canadian Interference-Causing Equipment
Regulations.
Cet appareil numérique de la classe A respecte toutes les exigences du Règlement sur le matériel
brouilleur du Canada.