Allied Telesis AT-PBC18 User Manual
Page 36
Installing a Power Supply Module
36
Caution
Power cord is used as a disconnection device: To de-energize
equipment, disconnect the power cord. (AC model only.)
! 10
5.
For an AC powered chassis, plug one end of the power cord to the
back of the power supply and plug the other end to a power outlet.
Proceed to
on page 39 for further instructions.
Note
If you purchased an optional management module, install the
module before applying power to the chassis. Refer to
on page 93 for installation
instructions.
6.
For a DC powered chassis, perform the following steps:
a.
Before attaching wires to the DC terminal block on the power
supply module, review the following warning:
Warning
As a safety precaution, a 10 Amp circuit breaker should be installed
at the supply end of the cable to be used with this LAN equipment.
Always connect the wiring to the LAN equipment first before
connecting the wiring to the breaker. To avoid the danger of
physical injury from electrical shock, do not work with HOT feeds.
Always be sure that the breaker is in the OFF position before
connecting the wiring to the breaker.
! 16