Allied Telesis AT-PBC18 - Manual (Page 35)

PowerBlade PBC18 Installation Guide
35
Installing a Main Power Supply
To install a main power supply, perform the following procedure:
1. Remove the PWR 1 blank faceplate from the back of the chassis by
loosening the two thumbscrews, as shown in Figure 12.
Figure 12 Removing the Main Power Supply Blank Faceplate
2. Remove the power supply from the shipping package and store the
packaging material in a safe location.
3. Slide the power supply into the expansion slot, gently seating the
power supply’s connector into the chassis’ backplane. See Figure 13.
Figure 13 Installing the Main Power Supply
4. Secure the power supply to the chassis by tightening the two
thumbscrews.
PBM02
Mana geme nt
MDI-X
MDI LNK STAT US
PWR RESET RS-23 2 Ter minal
10Base -T
PBM02
Mana geme nt
MDI-X
MDI LNK STAT US
PWR RESET RS-23 2 Ter minal
10Base -T