Allied Telesis FORMULA 8200 - Manual (Page 97)

FORMULA 8200 User’s Guide
5-19
ETHERNET/CONFIG/RXMIRROR Example
To set the receive mirror port for port mirroring:
Enter the following command:
ETHERNET/CONFIG> rxmirror
Refer to Using Ethernet Port Mirroring in Chapter 4 for more
information.
ETHERNET/CONFIG/SETSNOOP Example
To set the snoop (monitoring) port for port mirroring:
Enter the following command:
ETHERNET/CONFIG> setsnoop
Refer to Using Ethernet Port Mirroring in Chapter 4 for more
detailed information.
ETHERNET/CONFIG/STAT Example
To configure Ethernet statistics parameters:
1. Enter ETHERNET/CONFIG/STAT/PORT to enable statistics.
2. Use the ETHERNET/SHOW/STAT command to verify that
statistics is turned on, that is, port(s) are shown as Enabled .
/ETHERNET/CONFIG/STAT/PORT
Ethernet Port Statistics Configuration (Press to take
default value,
Q to Quit)
Enter port(s) number to configure (1..16)(,): 1-8
Enable port statistics? (y/n) (default=n): y
Port(s) to configure: 1-8
Collect poll statistics:Enabled
Enter (S=save, Q-quit):
s
............ Updating system/VLAN configuration ..........