Allied Telesis FORMULA 8200 - Manual (Page 27)

FORMULA 8200 User’s Guide
2-11
Configuring IP Information
1. Use the BOOT/IP/CONFIG and BOOT/IP/EEPROM commands
to configure Internet protocol information for the switch,
including:
❑ IP address
❑ Local host name
❑ Default gateway
❑ Subnet mask
The IP command displays the local IP configuration
parameters. After each parameter is displayed, the system
prompts you for any changes. If you don’t want to change any
parameter, press [Enter] at each prompt.
2. Enter the default gateway address again using the INET/
CONFIG/ROUTE/DEFAULT command:
INET/CONFIG/ROUTE/DEFAULT
gateway address ( ) : 149.35.27.1
3. Confirm your entry with the following command:
INET/SHOW/ROUTE
A similar table displays on the screen:
/BOOT/IP/CONFIG
Local IP configuration:
IP address (149.35.101.31) :
Local Host name (SWITCH#1) :
Default gateway (149.35.27.1) :
Net mask (255.255.255.0) :
OK to write config to flash (y/n) ? Y
Writing new configuration to flash ...
/BOOT/IP/EEPROM
EEPROM IP:
IP address (149.35.27.1) :
OK to write config to EEPROM (y/n) ? Y