Allied Telesis FORMULA 8200 - Manual (Page 96)

Command Reference
5-18
ETHERNET/CONFIG/PORT Example
To enable autonegotiation for Ethernet TX ports 1,2, and
3:
Note
100Base-FX fiber ports are fixed at 100 Mbps and full duplex and
cannot be configured.
1. Use the ETHERNET/CONFIG/PORT command.
2. Enter the desired information at the prompts, which are shown in
the display below.
If a port is set to other than the default, pressing the Enter key
resets it back to the default setting. It does not retain the
previously configured port setting.
Once you have responded to each of the prompts, the settings
are displayed, and you are prompted to save your responses
or to quit.
CONFIG
(continued)
FLUSH ALLPORT
allpf
Flush all Ethernet port entries
FLUSH UPLINKF
uplinkf
Flush all uplink entries
Table 5-5 ETHERNET Command Parameters (Continued)
Subcommand Alias Description
/ETHERNET/CONFIG> port
Ethernet Port Configuration
(Press to take default value, Q to Quit)
Enter port(s) number to configure (1...16) ():1 2 3
Autonegotiation enable? (y/n) (default=y): Y
Transmission enable? (y/n) (default=y):Y
Receiving enable? (y/n) (default=y): Y
Port(s) number to configure: 1 2 3
Autonegotiation enable? (y/n) (default=y): Y
Transmission enable? (y/n) (default=y): Y
Receiving enable? (y/n) (default=y): Y
Enter (S=save, Q=quit): S
Autonegotiation prompt