If the image file did not load successfully, reset, Press the reset button located on the front pan, Quickly press any key – Allied Telesis FORMULA 8200 User Manual

Page 153: Enter c to set the boot parameters for loading

FORMULA 8200 User’s Guide

C-7

This process replaces the previous firmware image file. The
image file update can take up to five minutes.

Note

If the image file did not load successfully, reset the switch and repeat
the procedure from the beginning.

8. Press the reset button located on the front panel to reset the

switch.

The following message appears:

9. Quickly press any key.

This returns you to the VxWorks operating system prompt:

[VxWorks Boot]:

10. Enter

to set the boot parameters for loading the new image file

from flash:

[VxWorks Boot]: Z

WARNING: you are about to zap a new firmware image into flash

Enter `y' to continue: y

boot device

: hs

processor number

: 0

host name

: server1

file name

: v1225.Z

inet on ethernet (e):192.34.140.20

host inet (h)

: 192.34.140.30

user (u)

: root

ftp password (pw)

: password

flags (f)

Attaching network interface hs0... done.

Subnet Mask: 0xffffff00

Attaching network interface lo0... done.

Zapping image to flash...

Press any key to stop auto-boot...