Allied Telesis FORMULA 8200 - Manual (Page 52)

Operating and Managing the FORMULA 8200 Switch
4-6
Configuring Ethernet Port Settings
Note
You cannot configure FX ports. They are fixed at 100 Mbps, full
duplex.
You can configure the following parameters for TX ports:
❑ Autonegotiation
❑ Port speed
❑ Port duplex
To configure Ethernet port parameters:
1. Use the ETHERNET/CONFIG/PORT command.
2. Enter new configurations, or accept the defaults.
For example, if the screen shows autonegotiation as being
disabled (
N ), and you want to keep it disabled, enter N again.
Otherwise, if you just press Enter, the autonegotiation reverts
to the default setting as enabled (
Y ).
/ETHERNET/CONFIG/PORT
Ethernet Port Configuration
(Press to take default value, Q to Quit)
Enter port(s) number to configure (1..16) ():1 2 3
Autonegotiation enable? (y/n) (default=y):N
Port speed (1=10MBPS, 2=100MBPS) (default=100MBPS):1
Half duplex/Full duplex (1=Half, 2=Full) (default=Half):1
Transmission enable? (y/n) (default=y):Y
Receiving enable? (y/n) (default=y): Y
Enter (S=save, Q=quit):
S