Allied Telesis FORMULA 8200 - Manual (Page 43)

FORMULA 8200 User’s Guide
3-11
Configuring a Virtual Bridge
A virtual bridge is created when you create a VLAN.
To configure bridge parameters for an existing
bridge:
1.
Enter the
VBRIDGE/CONFIG/BRIDGE command.
For example, enter:
BRIDGE 1
When you enter this command, a full menu of configurable
choices appears, as shown below:
2. Enter the desired information by entering the item number with
an equal sign (=) and the value.
3. Enter 0 at the prompt to save changes and exit the menu.
Caution
Do not change any of the values unless you are very familiar with
spanning tree parameters and how they affect the status of your
network. Incorrect settings can lead to serious network problems.
For more detailed information about this command and its
parameters, refer to the
VBRIDGE command in Chapter 5.
/VBRIDGE/CONFIG/BRIDGE 1
Spanning Tree Parameters Modification for VLAN 1:
1) Spanning tree Status is ON for this VLAN, set to OFF? (y/n)
2) New Priority (0..65535) (current value is 32768):
3) New Bridge Hello Time (1..10 secs) (current value is 2):
4) New Bridge Max Age (6..40 secs) (current value is 20):
5) New Bridge Forward Delay (4..30 secs)(current value is 15):
6) New Aging Time (10..1000000 secs) (current value is 300):
Enter selection (modification or 0 to commit, c to cancel) >