Downloading the firmware, Enter, Verify that the information displayed on the sc – Allied Telesis FORMULA 8200 User Manual
Page 68: Verify that the information on the screen is co, Reboot the switch either by using the reboot co, Downloading the firmware -22
Operating and Managing the FORMULA 8200 Switch
4-22
Downloading
the Firmware
To download:
The following steps provide the FORMULA 8200 with the
name of the switch system file that resides on your TFTP
server:
1. Enter:
TFTP/DOWNLOAD/FIRMWARE
2. Verify that the information displayed on the screen is correct and
enter
Y
. Then enter
Y
again to save the configuration to flash.
A similar screen appears:
3. Verify that the information on the screen is correct. Confirmation
of the above information invokes the TFTP download process.
This process takes approximately 5 minutes.
After the TFTP download process completes, the switch
system software is saved to flash memory and you see the
following prompt:
/TFTP/DOWNLOAD >
4. Reboot the switch either by using the
REBOOT
command or by
pressing the
Reset
button on the front of the switch
.
Rebooting enables the FORMULA 8200 to load the new
system software from flash to running memory (DRAM). The
system then runs and displays POST (power on self test) and
other diagnostic information, as shown in the following
example:
/TFTP/DOWNLOAD/Firmware
Name of file on tftp server (v13r28.z) :
File
firmware"
Are they correct? (y/n) Y
Save the configuration to flash? (y/n) Y